Hydraulic Pendant Switch Wire Harness

Drop-In Wire Harness for Hydraulic Lift Pendant Controllers

This wire harness is the replacement component for your hydraulic pendant switch. Designed to restore communication between the manual controller and the hydraulic lift system, the assembly provides the wiring pathways needed to transmit directional signals directly to the hydraulic power unit.

The exterior features a thick protective jacket that shields the internal wiring from friction and daily wear in demanding environments. The wires are bundled securely to keep the setup organized and prevent tangling during operation. Connection points are prepared for wiring directly into your existing pendant enclosure and the main lift control board.

Restores Pendant-to-Lift Communication

The harness provides the wiring pathways needed to transmit directional signals from the manual pendant controller directly to the hydraulic power unit. When a damaged or worn cable is interrupting that signal, this is the replacement that restores normal up/down operation.

Thick Protective Outer Jacket

The exterior jacket shields the internal conductors from friction, abrasion, and daily wear in demanding lift environments. Built to handle the kinds of repeated bends, drags, and grit exposure that destroy unsheathed cabling.

Bundled, Tangle-Free Construction

The internal wires are bundled securely to keep the setup organized and prevent tangling during operation. Cleaner routing inside the pendant enclosure, fewer snags during use, and easier service down the line.

Pre-Terminated for Direct Hookup

Connection points are prepared for wiring directly into your existing pendant enclosure on one end and the main lift control board on the other. No splicing or specialty connectors required, just match the terminals against your lift manual and tighten down.